: OMC 70 question


Johnny Appleseed
06-06-2005, 06:45 AM
Question for you OMC gurus/dealers:
I have a 1992 Evinrude 70 hp 3 cyl.
I have been told by several people that there is a service bulletin out for the cooling system on that motor, but have been to several OMC dealers who have known nothing about the TSB or been able to find it in their TSB's. I looked thru one dealer's book of TSB's and was unable to find it. You also canot call BRP about motors older than 95. So I am looking for answers here.
I already have the new water pump/thermostat, but there supposedly is a new location on the power head for the tell tale (pee-hole) output fitting that you are supposed to drill/tap. Does anyone know where the new location is? and how you are supposed to install it? also how are you supposed to fill in the old hole.

Thanks in advance

jegervais
06-06-2005, 11:08 AM
The bulletin is #2276 (revision 1), dated April 1994. It specifies the location to drill as well as a part number to plug the old hole.

-John

seahorse
06-07-2005, 11:03 PM
60 & 70 hp service bulletins for cooling and overheating

SB 2221 Temp sensor new sensor pn 584166, tan/blue stripe wire.

SB 2225 thermostat seat new seat pn 336416

SB 2271 jet and timing kits

SB 2276R1 relocate tattle tale nipple to top of block.

SB 2276R1 and new pressure relief springs comes in waterpump kit pn 432955.

#432995 water pump kit also includes new water tell-tale nipples and thermostat gaskets and springs for updating the motor