Ice Up of Lazer Mag Ultra

[rngrfshm]

Does anyone else have a problem with the Lazer Mag Ultra Icing up not cutting. I don't know if it is the 3 blade design or what but am in some need of advice to how to prevent this. I drill a hole and then on the next hole I go to, it just sits there and spins on the ice not cutting. I am not sure how to prevent this. I am wondering if anyone else has this problem and how to prevent it. I tried to run the motor after out of the hole to sping the water off and it still does it. Do they have a spray teflon or something I could put on the blades to deter water?

Thanks for the input.

[The Great Guide]

That's a new one on me. I've drilled hundreds of holes with my Lazer and have never had a problem. I do put new blades on each year.

TGG

[rngrfshm]

Thanks for the Reply Great Guy,

The unit is Brand new and only drilled 15 holes so far. I am having a hard time or must be doing something wrong. Not sure what is happening. I was hoping that some of the folks that bought the New 3 Blade design has any comments too. Not sure what to do for the amount of money that I spent on it. I like the unit, I just need to figure out how to not get it iced up or keep the ice off of the auger.

Thanks