10 hp rig

[rapman]

good morning. i fish inland lakes in northeast ohio and western pa. most of these lakes are loaded with walleyes, my favorite fish. i was thinking of purchasing a new rig. i am looking at a 14" polar craft with a 72 inch beam. this boat is very deep. what do you think? i need advice on how to set it up. anything of trolling motors. fishfinders, rod holders and the like. i looked at 16 footers, but the weight was much greater. any information would be appreciated. if any additional information is needed, i will provide it. thanks guys and tight lines.......

[FishHawk]

I have a 2002 14' Polar Craft, a very sea worthy boat. I have a 9.9 Johnson which I push the boat with, it does a fair job but my motor isn't the newest out there. I am thinking of purchasing a new motor and beef it up a little. I also have an18 h.p. merc. in my garage, which i will not part with if they go to the 18h.p. limit on Pymatuning.

[rapman]

thanks fish, how do you have that set up? are you using an electric and if so, stern or bow? looked at a 14 polar at the weigh-in for the last round-up at the state beach. was that yours? i cannot get over how wide and deep they are. i have been told that a new 9.9 4 stroke will push it real nice. what kind of electronics are you using? any info would be helpful. one more question.......S&H marine or pyma boat sales? thanks again...........