My 111 c hd is just flashing 60 ft depth on the sonar, and no detail shows up for Nauticpath.....any ideas?...Thanks....Tom

I had a problem with my depth not holding after years of good operation. I did a soft reset and it solved the problem.

Reset the unit:

Below are the instructions for the soft reset for your unit.

Soft Reset:
1. Turn unit OFF
2. Press and hold the PAGES key
3. Press and hold the PWR key
4. Release both buttons when the unit powers up to the alarm box

Good luck,

did'nt work..must be the transd.

Tom, you can check that transducer issue by hooking it to your other one, if you haven't already done that. Good advice from other posters on that 28 issue. When I first installed my 25's, I didn't have all the positive and negative wires hooked up, and got the same reading. I hooked all three units to my starting battery and it would not run them all day without kicking one of them off due to low voltage. The wiring instructions seemed kind of vague to me but then I'm kind of challenged in that area. Did have the same issue as your 111 but a new transducer fixed it. I had crushed the transducer wire in my trolling motor when stowing it. You could barely see where it had marked the outside wire cover, but when I took it apart, one of the wires had broken and the others smashed. Lesson learned by me when stowing motor. Lowrance stood behind it even though it was my fault.