jbwallskater
03-19-2009, 09:28 AM
I am new to the networking of Lowrance units and I am sure these questions have been asked, but I would like to know if the following will work. I recently bought an X37C combo unit for my boat, and want to rearrange my current electronics. My current setup is an X20C and an X102C with two trandsducers on the back of the boat. I want to mount the X37C on the dash, the X20C up front, and the 102C in the back.
1. Can I run the X20C and the X102C from the same transducer at the same time?
2. I already have holes for a second GPS puck so I am planning on keeping the X20 and X37 competely separate as far as mapping go, because I read that you can't read the same map chip on two different units at the same time. Is that true?
Any suggestions on possibly networking differently would be greatly appreciated.
Thanks in advance.
1. Can I run the X20C and the X102C from the same transducer at the same time?
2. I already have holes for a second GPS puck so I am planning on keeping the X20 and X37 competely separate as far as mapping go, because I read that you can't read the same map chip on two different units at the same time. Is that true?
Any suggestions on possibly networking differently would be greatly appreciated.
Thanks in advance.