hogridnfool
04-18-2009, 05:21 PM
I am going to replace the deck in my 1989 16' Lund rebel Special. The floor section that I will be installing is approximately 5'x10'. I cannot get oversized sheets of marine plywood locally so I am planning on using multple sheets of 4'x8'. My question is what is the best way of joining the sheets? My plan is to use a half lap joint over the stringers glued with Resorcinal or Gorilla glue and then Pop-rivet through the joint and stringer. Are there better ways of doing this job?
I have contacted Lund to see if pre-cut decks were available and was told that prior to 1990 they were hand cut for the specific job and that the patterns are no longer available.
I have contacted Lund to see if pre-cut decks were available and was told that prior to 1990 they were hand cut for the specific job and that the patterns are no longer available.