Catcrazy3
05-28-2009, 11:24 AM
I bought a used 3200 for the boat and it works very well. My problem is viewing waypoints on the screen. When I mark a waypoint they do not show up on the screen, but if I look in the waypoint menu they are there. I do the goto and the way point appears on the screen until I cancel navigation, then it disappears. I also noticed this with the way points I transferred from my handheld unit, they are in the list but not on screen.
I cannot find anything in the manual or in the menus that addresses this issue. Any one know what to do to get these to show up all the time. They always automatically did with my expedition handheld.
I don't think this should make a difference but I use the same Lakemaster-MN 2008 chip in it that I used in the expedition.
I cannot find anything in the manual or in the menus that addresses this issue. Any one know what to do to get these to show up all the time. They always automatically did with my expedition handheld.
I don't think this should make a difference but I use the same Lakemaster-MN 2008 chip in it that I used in the expedition.