link to homemade inline boards

[Boatnut]

For those of you on a budget..or who just enjoy tinkering, check out this link on how to build your own in line boards.

http://www.tnstripedbass.com/articlesplanerplans.htm

[Marble Eyes]

Good post Mike.

Here is another. This one is for the dual Runners.
I built a pair and the work great.

http://www.hallcrash.com/triflash/free/toppage1.asp

[marcbodi]

Hi,
Anyone else build these boards.I built them and they were terrible for me .They didn't run with the boat .They surged and even dove down.Maybe was just me.I hope everyone else had luck with them.

[marcbodi]

Hi,
I did reply to the dual boards.

[The Smalleye]

Marcbodi I made the boards on the plans and they run good for me, Had to tune them up alittle by switching holes until the pulled away from the boat at the right angle but all in all there was no big problems.

[Smitty]

I built my first one (the dual board) based on that plan, but haven't had the chance to try them yet. Hopefully within the next couple weeks.

I'm not sure how it will work, but I also shortened them up from what the plan specified as I don't think I'll need them to pull a large # of lines (maybe 2-3 lines per board). I'll try to post how they work as soon as I give them a try.

[marcbodi]

Hi Smalleye,
Great job I figured some one knew more than me.My problem was that I thought all boards should run like the ones I use Right even with the boat.Their problem is they don't have a lot of line tension on them Like the offset boards have.