steves
05-23-2000, 11:51 AM
I have a 3700 Motor along with a 7520 mounted at both the bow and console. I have the CBAY20 cable connecting the two 7520's
together and I have a Multitransducer Y cable connecting both a transom mount transducer with speed/temp along with a puck
transducer mounted in the bottom of the boat. Now the problem...When I first connect the cables to the 7520 and then power it on,
the 7520 will recognize both transducers and work fine until I turn off the 7520. When I turn the 7520 back on the 7520 doesn't
recognize either transducer and goes into simulation mode..If I then turn off the 7520 and unplug both cables and wait about 15
seconds and then plug the cables back in, the 7520 will then recognize both transducers again. Now, if I eliminate the multitransducer
Y cable and plug each transducer in seperately the 7520 comes up every time with the puck transducer but never comes up with the
transducer with speed/temp. I get the same functionality on both of the 7520's. Has anyone else experienced these symptoms???
together and I have a Multitransducer Y cable connecting both a transom mount transducer with speed/temp along with a puck
transducer mounted in the bottom of the boat. Now the problem...When I first connect the cables to the 7520 and then power it on,
the 7520 will recognize both transducers and work fine until I turn off the 7520. When I turn the 7520 back on the 7520 doesn't
recognize either transducer and goes into simulation mode..If I then turn off the 7520 and unplug both cables and wait about 15
seconds and then plug the cables back in, the 7520 will then recognize both transducers again. Now, if I eliminate the multitransducer
Y cable and plug each transducer in seperately the 7520 comes up every time with the puck transducer but never comes up with the
transducer with speed/temp. I get the same functionality on both of the 7520's. Has anyone else experienced these symptoms???