View Full Version : How do you repair a Bulldawg?
Bad Santa
07-18-2010, 03:41 PM
Pulled out a new 'dawg on my trip to Canada, first time I had ever used one. 2 casts and had a hit! I guess I should be happy with a 39" northern, but it wasn't a musky, @#* it. While working to remove the hooks, the fish spun in the net and tore the tail of the 'dawg about half-way off. Is there some way to repair this? Or, is it use it 'till it's gone? Thanks for any help.
Esoxchaser
07-18-2010, 04:22 PM
Heat weld it with an electric soldering iron.
ffishman
07-18-2010, 04:44 PM
Not sure about a Bull Dawg, but I've seen guys weld two pieces of worms together with a lighter.
went522
07-18-2010, 05:30 PM
A lighter works well...melt it and push together. I also use a small bottle of "soft plastic glue" that does a good job.
BIRDDOG
NP4ME
07-19-2010, 10:21 AM
What about replacement tails if the tails are completely torn off?? Any suggestions? Thanks!
sammy2964
08-17-2010, 09:39 PM
super glue the damaged area first, then light the wet glue, it burns well and long enough to melt the damaged area together really well.
muskyhunter34
09-01-2010, 01:20 PM
BUT IF MY MUSKY LURE BROKE, i'D BUY A NEW ONE...MENDING LURES ONLY MAKES FOR MISSES!!:frypan: