Boat Hardware

[Ebox]

Recently mounted new electronics and had to drill (about a 3/4 to 1 inch hole)through the dash for wiring. Does anyone know the best place to get hardware to finish off the hole where the wires go into the dash. Would like to make it look finished and also don't want to cover the hole that goes into the glove box storage. I have seen them on some new rigs and also there is a fairing in the most current Bass & Walleye boats issue, but haven't been able to find the right stuff.
thank you - erik

[REW]

both Cabella's and Bass Pro - have "hole caps".
These are caps designed expressly to handle the large holes required for transducer connectors, and then leaving a small hole for the cable exit.

Most "good" marine dealers stock them as well.

take care

REW