Blowing Fuses

[Tom22]

All of a sudden I am blowing fuses, as soon as I turn on the graph the fuse blows, this has just started doing this, although it dose'nt do it every time but it happens 75% of the time, any suggestions?

[mikey]

You will need to follow the wires from your graph all the way to your power source. You most likley have a bare spot on the wire touching metal which is causeing a direct short and blowing fuse. Any vibration could cause the bare spot to touch metal. If all the wiring checks good then its your graph in need of repair. You will need to find a repair shop for that. Good luck.

[Tom]

Tom 22, You have a short in your graph. Tom

[Tom22]

I should further note that the fuse blows immediately when I install it at the main board,(meaning I don't neccesarily have to turn the graph on to have it blow,Some other electronics are also hooked to this fuse, which also are not turned on at the time)