Home   |  Message Board   |  Information   |  Classifieds   |  Features   |  Video  |  Boat Reviews  |  Boat DIY
Walleye Message Central - Search Results
Walleye Message Central

Go Back   Walleye Message Central > Search Forums

Showing results 1 to 25 of 500
Search took 0.13 seconds.
Search: Posts Made By: wiredog
Forum: General Discussion 08-28-2021, 11:50 AM
Replies: 11
Views: 2,675
Posted By wiredog
Yup stay under 70. Those 3.92 gears love 65 and...

Yup stay under 70. Those 3.92 gears love 65 and hate 70+. Wiredog
Forum: Boats 08-05-2020, 11:53 AM
Replies: 14
Views: 2,495
Posted By wiredog
Take and spin the setting screw back and forth a...

Take and spin the setting screw back and forth a few times and then put it back to the setting before you changed it. That will most likely fix it, The contacts inside get dirty and this will most...
Forum: Motors and Props 08-01-2020, 06:49 PM
Replies: 2
Views: 723
Posted By wiredog
Yes it will. Wiredog

Yes it will. Wiredog
Forum: General Discussion 12-18-2019, 10:44 AM
Replies: 41
Views: 7,792
Posted By wiredog
There is only one, HONDA,. Wiredog

There is only one, HONDA,. Wiredog
Forum: Boats 09-29-2019, 06:39 PM
Replies: 14
Views: 1,565
Posted By wiredog
I don`t go by prop slip numbers. I go by gps...

I don`t go by prop slip numbers. I go by gps speed and the tack on my smart craft gauge. 2 Guys, 30 gal. gas my normal fishing gear, worked Trophy about a 24 not a plus but an early one with the thin...
Forum: Motors and Props 09-28-2019, 08:48 PM
Replies: 21
Views: 9,916
Posted By wiredog
Its not the trolling motor batterys that run out...

Its not the trolling motor batterys that run out of power. Its the i pilot link remote that runs out of battery power after about 5hrs. That little rechargeable battery just does`nt last very long. ...
Forum: Boats 09-28-2019, 08:15 PM
Replies: 14
Views: 1,565
Posted By wiredog
You won`t ever see close to 70. Maybe 62 or 63...

You won`t ever see close to 70. Maybe 62 or 63 check your propshaft to pad hight. Should be 3 1/2 to 3 3/4 inch. And yes a worked Trophy with a vent sleeve on it will run badass on that boat. Oh and...
Forum: Motors and Props 09-01-2019, 08:51 PM
Replies: 19
Views: 6,030
Posted By wiredog
3 3/4 inch prop shaft center to bottom of pad and...

3 3/4 inch prop shaft center to bottom of pad and try a Trophy Plus 23 pitch with a anti vent ring on it. Wiredog
Forum: Motors and Props 08-18-2019, 10:24 AM
Replies: 5
Views: 1,680
Posted By wiredog
Some of the early Optis. had a problem with that...

Some of the early Optis. had a problem with that seal getting pushed up from lower unit grease building pressure. My 03 225 Opti. did that same thing. Merc. makes that seal as a high performance one...
Forum: Motors and Props 08-12-2019, 09:30 PM
Replies: 9
Views: 2,858
Posted By wiredog
here is a link to the proper way of doing water...

here is a link to the proper way of doing water pump on your Merc. it is from Bass Boat Central-SHERM' TIPS
STTipsWP2.webarchive (COPY AND PASTE IN LINK)

Wiredog
Forum: Motors and Props 08-08-2019, 10:21 PM
Replies: 13
Views: 2,012
Posted By wiredog
Just telling you what Merc. says. That being said...

Just telling you what Merc. says. That being said i did`nt prime mine. But also watched that no oil ran out of the hoses and did`nt have any problems. Maybe i just got lucky. The lower filter is not...
Forum: Motors and Props 08-04-2019, 04:07 PM
Replies: 13
Views: 2,012
Posted By wiredog
Cool Yes you can do that. But it most likely will cost...

Yes you can do that. But it most likely will cost you a set of fouled spark plugs. And can put it in 10hr. break in mode. But to each their own!! Wiredog
Forum: Motors and Props 08-03-2019, 11:47 AM
Replies: 5
Views: 1,218
Posted By wiredog
What he said!!!

What he said!!!
Forum: Motors and Props 08-02-2019, 06:43 PM
Replies: 5
Views: 1,218
Posted By wiredog
You are comparing apples to oranges. Those must...

You are comparing apples to oranges. Those must be two totally different props. Wiredog
Forum: Motors and Props 08-02-2019, 06:36 PM
Replies: 13
Views: 2,012
Posted By wiredog
Smile The front of the engine is where the intake is....

The front of the engine is where the intake is. the back of the engine is where the spark plugs are. Mercury recommends that when you replace those oil filters for the compressor you take the boat...
Forum: Motors and Props 08-02-2019, 05:56 PM
Replies: 13
Views: 2,012
Posted By wiredog
That one is also an oil filter. at least on my...

That one is also an oil filter. at least on my 225. the hose from that filter goes to fill the oil tank on the engine . The other two if you trace the lines go to the air compressor. The only fuel...
Forum: Motors and Props 08-02-2019, 05:04 PM
Replies: 13
Views: 2,012
Posted By wiredog
The top white one is backwards. the large end of...

The top white one is backwards. the large end of that filter should go towards the front of the engine. If you follow the lines you will see that they go too the air compressor. one takes oil to the...
Forum: Motors and Props 08-02-2019, 04:41 PM
Replies: 13
Views: 2,012
Posted By wiredog
Those are NOT fuel filters they are oil filters...

Those are NOT fuel filters they are oil filters for the compressor. The larger red cap in the picture is the fuel filter. I need to take the cover off my boat to tell you which way they go.Give me an...
Forum: Swap Board 06-16-2019, 08:43 PM
Replies: 3
Views: 996
Posted By wiredog
ttt

ttt
Forum: Swap Board 06-12-2019, 01:51 PM
Replies: 3
Views: 996
Posted By wiredog
txt

txt
Forum: Swap Board 06-09-2019, 12:52 PM
Replies: 3
Views: 996
Posted By wiredog
PTSv Motorguide 60" 36 volt trolling motor

works perfect/lots of extras $425-WILL NOT SHIP.
For more info PM wiredog.
Forum: General Discussion 05-26-2019, 09:02 PM
Replies: 7
Views: 2,836
Posted By wiredog
Thumbs up Find the screw on the back of tack. There will be...

Find the screw on the back of tack. There will be letters or numbers stamped on case by the screw or knob. the screw or knob will have a mark or arrow to coraspond to the marks around it. Spin the...
Forum: Electronics 03-30-2019, 01:32 PM
Replies: 13
Views: 2,385
Posted By wiredog
The new mega version will not work at all with...

The new mega version will not work at all with your 898. I just went threw that. I have three 958di,s networked and did,t want to buy new graphs so i bought an new Ulterra with the older 2d...
Forum: Electronics 03-17-2019, 07:45 PM
Replies: 19
Views: 3,297
Posted By wiredog
So its not a gps puck? Wiredog Never mind its...

So its not a gps puck? Wiredog Never mind its amazing what a person can learn when they read the manual. LOL
Forum: Electronics 03-17-2019, 12:54 PM
Replies: 19
Views: 3,297
Posted By wiredog
Question Pondering !!

I`m getting ready to install my Ulterra link on my boat and i already have an HS puck hooked to my networked birds. Will there be a problem when i also install the link gps puck into the system?? ...
Showing results 1 to 25 of 500

 
Forum Jump

All times are GMT -6. The time now is 05:49 PM.


Powered by vBulletin® Version 3.8.8
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
vBulletin Security provided by vBSecurity v2.2.2 (Pro) - vBulletin Mods & Addons Copyright © 2024 DragonByte Technologies Ltd.