Forum: Boats
08-13-2017, 08:35 PM
|
Replies: 3
Views: 975
If your talking about the rubber trim in the...
If your talking about the rubber trim in the channel of the windshield, just take a small screwdriver to pry it up. Then pull it out. It is quite simple and should give you access to the tops of the...
|
Forum: Boats
08-09-2017, 05:36 PM
|
Replies: 14
Views: 3,924
They are not hard to launch or retrieve. Wait...
They are not hard to launch or retrieve. Wait till you tow it with a 20-30 mph crosswind. They do make an excellent platform for most anything, if I had a lake house, I would have a pontoon tied up...
|
Forum: Boats
08-09-2017, 05:33 PM
|
Replies: 32
Views: 14,752
|
Forum: Trailers and Tow Vehicles
08-09-2017, 08:52 AM
|
Replies: 8
Views: 1,468
On my last trip traveling almost 2200 miles. I...
On my last trip traveling almost 2200 miles. I was wondering if my surge brakes were engaging on every down hill travel. Then I thought, if that were the case I am truly dragging the boat down hill...
|
Forum: Trailers and Tow Vehicles
08-08-2017, 06:47 PM
|
Replies: 45
Views: 6,186
|
Forum: Trailers and Tow Vehicles
08-07-2017, 12:18 PM
|
Replies: 5
Views: 1,457
|
Forum: Trailers and Tow Vehicles
08-06-2017, 08:35 PM
|
Replies: 45
Views: 6,186
|
Forum: Boats
07-20-2017, 08:22 AM
|
Replies: 101
Views: 41,880
|
Forum: Boats
07-17-2017, 03:44 PM
|
Replies: 6
Views: 1,330
|
Forum: Boats
07-17-2017, 07:11 AM
|
Replies: 16
Views: 4,308
|
Forum: Boats
07-17-2017, 07:09 AM
|
Replies: 24
Views: 24,405
I posted my experience with Skeeter on there...
I posted my experience with Skeeter on there Facebook page. The top guy from customer service called me within 48 hours and ordered me a new boat. Personally I would have been happy with them fixing...
|
Forum: Boats
07-15-2017, 10:32 PM
|
Replies: 16
Views: 4,308
|
Forum: Boats
07-15-2017, 07:31 PM
|
Replies: 16
Views: 4,308
|
Forum: Boats
07-15-2017, 07:24 PM
|
Replies: 16
Views: 2,319
|
Forum: Boats
07-15-2017, 07:10 PM
|
Replies: 24
Views: 24,405
Suppose it is already mounted in the lowest...
Suppose it is already mounted in the lowest position as well?
Yeah as I think about this, I would definitely press them for a different boat. And let them figure out the power plant on it....
|
Forum: Trailers and Tow Vehicles
07-15-2017, 07:01 PM
|
Replies: 8
Views: 1,601
|
Forum: Motors and Props
07-14-2017, 07:28 PM
|
Replies: 16
Views: 2,794
I trout fish all year long. Our water temps...
I trout fish all year long. Our water temps rarely gets below 40. But I have never had a problem with my Yamaha F200 either. My old two stroke merc was a little tricky to get started in the winter...
|
Forum: Boats
07-14-2017, 06:54 PM
|
Replies: 16
Views: 4,308
|
Forum: Boats
07-14-2017, 06:41 PM
|
Replies: 24
Views: 24,405
|
Forum: Boats
07-11-2017, 09:09 AM
|
Replies: 51
Views: 12,211
I put one of these on my MX1825.
...
I put one of these on my MX1825.
https://www.ramp-n-clamp.com/
I took pictures of my bow roller and stanchions, emailed it to them to get one that would work. I did have to grind down the...
|
Forum: Boats
07-11-2017, 09:04 AM
|
Replies: 101
Views: 41,880
|
Forum: Trailers and Tow Vehicles
07-11-2017, 08:23 AM
|
Replies: 3
Views: 829
Yeah but now that the damage is done I need to...
Yeah but now that the damage is done I need to replace the rotor/hub combo. Considering the hub is built into the rotor and these are vault hubs I am considering replacing both with a different...
|
Forum: Electronics
07-10-2017, 04:38 PM
|
Replies: 2
Views: 1,953
|
Forum: Trailers and Tow Vehicles
07-10-2017, 04:34 PM
|
Replies: 3
Views: 829
Brakes
On my sleazyloader I have UFP DB-35 hub/rotor on a torsion axle. Today I went to bleed replace the fluid after three years of running this setup from new. One side pads were completely gone, the...
|
Forum: Trailers and Tow Vehicles
07-10-2017, 08:52 AM
|
Replies: 45
Views: 6,186
|