|
|
|
#11
|
||||
|
||||
|
I have read about problems with water in fuel causing injector failers.
I read up on other motors and found they all can have issues. That said I pulled the trigger on a new Starweld 18 with the 115 Etec. The Etec is amazing. I also run XD100 and plan on leaving the motor set at the 50:1 ratio. The 115 has exceeded my expectations so far, as with everything time will tell. I feel better about the Etec after running it than I did on the day I bought it. I`d like to have a second boat that had a 50 hp Etec, everyone seems to say these are the crown jewel of the Etec brand. Last edited by whofan; 07-04-2012 at 09:39 PM. |
| Sponsored Links | ||
Advertisement | ||
|
#12
|
||||
|
||||
|
I have had my 75hp E Tec for 6 years now. Bought it new with my boat in 2006. I can't say enough good about this motor. I have put over 500 hours on it, and it still starts first bump of the key every time. It SIPS fuel and oil. It is as quiet as a 4 stroke, and sounds really sweet wide open. The only issue (other than some initial rigging problems--dealers fault) is that it would go through plugs about every 180 to 200 hours when I trolled a lot. Bought a kicker so that is not an issue any longer. It pushes my boat on plane very quickly, and gets me up to around 33mph WOT with a 13"x13 pitch prop. When I had a 15 pitch it would push me about 38 mph. I have never winterized mine. Living in NM I fish year round. I just tilt the motor down and bump the key to get the last of the water out. Winterizing is a breeze however. There are a couple of simple steps, and you do everything from the helm.
__________________
----------------------------- Living outside the asylum. |
|
#13
|
|||
|
|||
|
Quote:
|
|
#14
|
|||
|
|||
|
Thanks Joe!
G44 |
|
#15
|
|||
|
|||
|
I have a 2008 75 E-TEC tiller model on a 2007 Lund Explorer1700. The E-TEC is one sweet piece of machinery! Instant starts, sips fuel and oil, quiet, great torque and easy off season storage!
Jim Last edited by Johnnielund; 07-09-2012 at 06:18 AM. |
|
#16
|
||||
|
||||
|
Quote:
At idle up to 2500 RPM its nearly as quiet as a fourstroke. I can hear my Etec running at idle. Some Fourstrokes are so quiet you can`t hear them. I would have to believe the small Etecs are quieter than my 115 making them very quiet . I`d right now would put the Etec at the #1 spot on my shopping list. I`m new to Etec so I hope my opinon doesn`t change in time. I always thought OMC was the best years ago so I have a bit of bias as well. There`s not a new outboard out there that I would not buy they are all good. |
|
#17
|
|||
|
|||
|
So this motor runs very well and has alot of tourqe but the tiller handle is junk. I ran this 2012 75 on a 1785 Yarcraft tiller and the handle is very akward compared to the new Merc's, Yammy's, and Honda's that I have expirence with. When you take your hands off it bounces like crazy, has akward turn and throttle tension hardware, is very long and thin and the steer hydralic has a giant ugly arm unlike the others i described above.
Again it ran great but for how much time I have my hand on a tiller handle these is alot of area for imprvement here IMO. |
![]() |
| Thread Tools | |
| Display Modes | |
|
|