|
#21
|
||||
|
||||
I have an '08 Lund with live well drains and plugs in the bottom of the wells. The plugs don't bother me and work ok, but when the stern well had the plug in, recirc running, the live well filled to the point where the water level reached the overflow (thru the side of the boat) water would splash over the top of the live well and spill into the bilge. I bought a couple of tubes with a rubber seal on the end which fit in the drain hole. I cut the length so water would flow out the tube/drain keeping the water level below the built in live well overflow. I have several tubes of different lengths so I can set the live well water level where I want it. And....it makes it easy to grab the tube, twist and pull, to completely drain the live well. I thought about leaving the tubes long and drilling holes in the tube at the desired water level. Then you could pull the tube and drain completely without getting hands in the water. Hope this makes sense.
|
Sponsored Links | ||
Advertisement | ||
|
#22
|
|||
|
|||
Quote:
wmd |
#23
|
|||
|
|||
I added flow rites cable system to my Lund crossover. I do not care if it starts leaking a little bit because I have to have the livewell empty before I leave the boat launch. I do not have a boat slip otherwise maybe the original system would be fine. It was not very pricey to add flow rites system . You just need some long skinny arms to get to the livewell drain hose.
|
#24
|
|||
|
|||
Quote:
|
#25
|
|||
|
|||
Quote:
Paul |
#26
|
|||
|
|||
Mine drain plug is a side outlet, it used a twist plug, not sure how this would work.
|
#27
|
||||
|
||||
Try to explain water in any amount of water in your live-well to the weed police
|
#28
|
|||
|
|||
I keep my boat on the same lake, we have our own boat ramp, so its never an issue for me thankfully.
|
#29
|
||||
|
||||
Quote:
My new Lund has the plug and I would rather have that than replace the valves again. Plus when they start leaking they get air locked and wont pump water, at least that was my experience. Last edited by hoytshooter; 05-20-2017 at 07:20 PM. Reason: needed to add more info |
#30
|
|||
|
|||
Quote:
|
Thread Tools | |
Display Modes | |
|
|