|
#1
|
||||
|
||||
Boat Buddy/Snapper Remote Control Boat Latch
Anyone have any experience with either of these on a Ranger 619 and Ranger Trail Trailer? Pros/cons? Thanks in advance.
|
Sponsored Links | ||
Advertisement | ||
|
#2
|
||||
|
||||
the boat buddy 2 works great for me. Never tried the snapper remote, never seen one.
__________________
We'll see you on the water Rebs |
#3
|
||||
|
||||
|
Sponsored Links | ||
Advertisement | ||
|
#4
|
||||
|
||||
Rebs, do you have a 619. Boat Buddy says I need the Boat BuddyI for my boat. It has a 3/8 bow eye.
|
#5
|
||||
|
||||
Quote:
when you drive your boat on the trailer just go slow and don't ram it into the boat buddy That snapper looks good too but it is expensive 399.99
__________________
We'll see you on the water Rebs Last edited by rebs; 09-11-2011 at 08:54 AM. |
#6
|
||||
|
||||
You must have the 1/2 inch bow eye or did you change to 1/2 inch from 3/8?
|
#7
|
||||
|
||||
I use the boat buddy 2 with the 3/8 inch eye that was on the boat. It matched up perfect, the 1/2 inch was a little longer. But I didn't need it to be any longer than the 3/8 was.
The boat buddy 2 is a little bigger unit than the boat buddy 1.
__________________
We'll see you on the water Rebs Last edited by rebs; 09-11-2011 at 12:30 PM. |
#8
|
||||
|
||||
Thanks Rebs, I will need to make a decision. Looks like the Buddy 2 if I go that direction. Cheaper than spending $400.00 and I'm still trying to find out if the Snapper will work on my boat the way the winch stand is set up with the swing way tongue.
|
Thread Tools | |
Display Modes | |
|
|