Lowrance Structure Scan Help

[BBG Marine]

Originally Posted by DRICH

Thanks for the post Brian. I'm going to recheck everything on thursday night when i have a few minutes. Is it ok to have both power wires on the same switch like I have it?

Yes, as long as you have both (yellow/red) on a switch that will cut power, you will be fine.

One side note...there have been some complaints of the "no source" message coming up on some GEN2 units after the latest software updates (1.1.39) are installed. I believe Navico support is looking in to it.

Brian

[DRICH]

That is the version I have on my friends boat.

[DRICH]

I emailed them the other day but have not heard back from them yet. I hope this does not turn in to one of the classic poor CS from Lowrance.

[jopes]

I would forget email and just call them on the phone.

[DRICH]

I will give them a call tomorrow.

[DRICH]

I had time to look at my friends boat again and took the advice that was given to me here. I tried another port on the scan box and now it works. So I have a bad port on the scan box. Looks like a road trip to Cabelas to return it. Thanks to all for the help.