|
|
|
|
#1
08-05-2012, 12:30 PM
|
|||
|
|||
08 Smartcraft guages
I have two Smartcraft gauges a Speedo and a Tach,
Is there a way to see trim percentage? I've gone through the menus on both but haven't found anything, is there a option to select in a menu? Gauges are for a 250 Pro XS 
|
| Sponsored Links | ||
Advertisement | ||
|
#2
08-05-2012, 03:22 PM
|
|||
|
|||
|
Should be. There's a way to activate the different features. Been so many years since I've messed with it though that I couldn't tell you how. All I remember that trying to calibrate the trim was a major pain in the you know what, so I gave up. LOL I think there should be a manual online thru Merc.
|
|
#3
08-05-2012, 03:35 PM
|
||||
|
||||
|
on page #19 of the online user manual http://www.mercurymarine.com/media/m...ners_Guide.pdf it shows how to calibrate the trim display, provided your engine has the digital trim sender installed.
this thread should help too. http://www.bbcboards.net/mercury-3-l...tallation.html HRG
__________________
"I've got a car with a trailer hitch, and a pocket full of money. Do you want to sell that boat today, or not?" My Mentor, Bill Michalek, circa 1975
|
|
#5
08-12-2012, 07:08 AM
|
|||
|
|||
|
Well now what?
Took the boat out and (after printing off instructions) ran thru the menu's.
There was a option to calibrate (which I did) the trim but no option to VIEW the trim angle on the LCD display? Question: Is there a way to install a trim angle guage? Motor is a Mercury 08 250 Pro XS
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
