|08-17-2015 10:25 AM|
Generally speaking, if there are fuses in a motor starting circuit they are all generally located in or on the motor and not on the boat or part of the boat's wiring.
Sorry, I just reread your original post. I see that you have an I/O configuration. Yes, in that case, the fuses could be located elsewhere in the boat.
|08-17-2015 10:10 AM|
|08-16-2015 10:37 PM|
I think that the easiest thing to do, is to cycle all of your accessories, lights etc. and make sure that everything works.
Then, just turn on one accessory and pull fuses until that unit quits. Mark that fuse and move on.
Continue the search until you have identified all of the accessories.
Or, you could turn everything on - and pull a fuse - then note what shuts off and then mark the fuse.
|08-16-2015 05:20 PM|
1988 Lund Baron 2100V - Fuse Block / Layout
Recently purchased an 88 lund baron 2100V(4.3/205hp/OMC), so far absolutely love this boat. Have been going through maintenance items and ran into an issue that I haven't been able to solve with google ;-)
I'm looking for a pic/photo/diagram of the fuse layout(placement/size) in both the side panel and the main dash. I can't read any of the desctriptions/lettering on the panels.
I do have the OMC wiring diagram which gets me partway there, but frankly I would have to pull the panel's off and ID the wire colors to figure out which fuse is which.
Any assistance would be much appreciated.
Mike in Minnesota