Home   |  Message Board   |  Information   |  Classifieds   |  Features   |  Video  |  Boat Reviews  |  Boat DIY
Walleye Message Central - Search Results
Walleye Message Central

Go Back   Walleye Message Central > Search Forums

Showing results 1 to 25 of 377
Search took 0.02 seconds.
Search: Posts Made By: EasternWashingtonBoater
Forum: Motors and Props 07-26-2021, 11:35 PM
Replies: 20
Views: 1,133
FWIW, once I screwed up and hooked up a 12V...

FWIW, once I screwed up and hooked up a 12V Minn-Kota cable steer in-series instead of parallel, realized it once it was going and really liked the extra thrust - figured I'd buy a 24V when it dies...
Forum: Boat Loans / Extended Warranties 101 07-21-2021, 08:35 AM
Replies: 11
Views: 3,049
The post above this one on the previous page is...

The post above this one on the previous page is blatant plagiarism. Wow. How weird.
Forum: Electronics 07-14-2021, 11:21 PM
Replies: 21
Views: 879
I tried the Genesis process, I'd gotten a years'...

I tried the Genesis process, I'd gotten a years' worth for a few bucks; a Cabela's clearance. Turns out CMAP Genesis' folk honored the old insert I'd found in the box, after being rejected online. ...
Forum: Boats 06-28-2021, 07:53 PM
Replies: 7
Views: 760
I went through a process with my livewells. May...

I went through a process with my livewells. May not apply to you.

1. When underway, the water intake, which on my boat looks like a half-cylinder with a screen made of reeds on the bottom, can...
Forum: Boats 06-26-2021, 12:41 PM
Replies: 54
Views: 12,754
I once had a plug pulled out by lily pads,...

I once had a plug pulled out by lily pads, backing out or something. Didn't notice until the floor was wet. By that time, the water was over the battery terminals. Slammed on the bilge pump...
Forum: Boats 06-18-2021, 07:52 PM
Replies: 6
Views: 567
Do you have a picture of the wires? How do...

Do you have a picture of the wires?

How do you know they were cut?
Forum: General Discussion 06-06-2021, 10:14 AM
Replies: 11
Views: 1,291
I've caught a few Musky, by accident, on...

I've caught a few Musky, by accident, on monofilament while fishing for Bass. Usually, when a Musky strikes, its a cut line but if one's really fishing stealthily, setting the hook at the tip of the...
Forum: Boats 06-06-2021, 09:56 AM
Replies: 9
Views: 1,126
When it came time to add a transducer board, I...

When it came time to add a transducer board, I decided to avoid drilling any holes into my transom. So I bought a Stern Pad, even put up a short review here on this forum (April, 2019).
...
Forum: Boats 06-01-2021, 01:37 PM
Replies: 17
Views: 1,692
I have a tandem too. Get some garbage bags,...

I have a tandem too. Get some garbage bags, bigger is better, and roll the trailer onto the bags and it will turn very easy. The two halves slip by each other like Teflon.

Lots of bags for a few...
Forum: Positive Trader Feedback 05-22-2021, 06:14 PM
Replies: 0
Views: 297
Nysrx -

Had a good experience with Nysrx; I purchased a HDS 9 G2T from him which arrived ASAP well packed; communication is quick and efficient and he went out of his way to find me a matching cover which...
Forum: Swap Board - $500 LIMIT ON ALL POSTS, INCLUDING WTB. 05-22-2021, 01:12 PM
Replies: 3
Views: 521
Pm sent

Pm sent
Forum: Boats 05-20-2021, 07:32 PM
Replies: 5
Views: 627
I hear your plight. I have no idea what I'd do...

I hear your plight. I have no idea what I'd do but here's one thought ...

If it's in a slip with a front and two sides, why not obtain (create) a roller canvas tarp sort of thing that you can...
Forum: Boats 05-19-2021, 01:49 PM
Replies: 7
Views: 1,127
Correction it is the 2006 Trophy 190, not 200,...

Correction it is the 2006 Trophy 190, not 200, that is 18'10".
Forum: Boats 05-18-2021, 11:23 PM
Replies: 7
Views: 1,127
I have a static jack plate (non-hydraulic) on my...

I have a static jack plate (non-hydraulic) on my 2006 Tournament Sport 185 (F200V6) - that year they were 18'9". In fact, that year the TS 185 was an inch longer than the Trophy 200!! Alumacraft...
Forum: Boats 05-18-2021, 11:02 PM
Replies: 25
Views: 4,622
I like my Drotto, but it's not foolproof. I have...

I like my Drotto, but it's not foolproof. I have a 2006 TS 185 (~19') with a F200 V6 engine, and a tandem EZ loader. Two times now, I've put the trailer in not quite far enough, and tried to roll...
Forum: General Discussion 05-07-2021, 02:18 PM
Replies: 75
Views: 5,925
As for me, I'm a peak-oiler - I believe that oil...

As for me, I'm a peak-oiler - I believe that oil production peaked way back in 2005 - and we're on the undulating plateau that will eventually shark-fin down. There was very active site, called...
Forum: Electronics 05-04-2021, 01:03 AM
Replies: 4
Views: 382
Some more pictures!

Some more pictures!
Forum: Electronics 05-04-2021, 12:57 AM
Replies: 4
Views: 382
Preparation and Install

It's hard to get the screws in straight enough to use the included backing plates with the same-size hole, so drilling will be a little bigger so the screw can be wobbled-in. It takes a little...
Forum: Electronics 05-04-2021, 12:42 AM
Replies: 4
Views: 382
Blue Water "Super Rock" 10" Unbox/Install

Maybe this will help you decide to buy one of these sturdy mounts. Pictures speak for themselves!

This is what you get ...
Forum: Electronics 04-29-2021, 11:28 AM
Replies: 5
Views: 432
Thanks for the suggestion. The problem with the...

Thanks for the suggestion. The problem with the bps unit is the top, holding the gimbal, can't twist forcing the screen to face the same direction of the arm. The solutions I listed allows two...
Forum: Electronics 04-28-2021, 01:33 PM
Replies: 5
Views: 432
Thanks for the suggestion. The three solutions I...

Thanks for the suggestion. The three solutions I identified were:

1. RAM double ball mount. Huge ugly plastic monstrosity.
2. TraxsTech EPM-DP...
Forum: Electronics 04-27-2021, 07:57 PM
Replies: 8
Views: 626
I had the same kind of dream, to restore my...

I had the same kind of dream, to restore my pinpoint PCSA stuff - this is the system they had out in 2006 ... bought the upgraded pinpoint panel on eBay and stuff - but gave up on getting it all...
Forum: Boats 04-27-2021, 02:12 PM
Replies: 21
Views: 2,588
Nice! Is that a 72" troller shaft? Seems...

Nice!

Is that a 72" troller shaft? Seems awfully long!


Something about bilge water ... I was getting water come out of my bilge when pulling the plug, sometimes quite a bit. So I began the...
Forum: Electronics 04-27-2021, 02:02 PM
Replies: 5
Views: 432
Help me Mount HDS 9 on Alumacraft TS Sport 185 (2006)

I need to mount my HDS-9 on my gunnel, with some kind of extension that brings it up somewhat behind the windshield. Problem is, there's no "samples" to try - so I'd like to know what others have...
Forum: Motors and Props 04-24-2021, 06:29 PM
Replies: 17
Views: 1,803
Making oil is also a consequence of unwell seated...

Making oil is also a consequence of unwell seated rings. When an engine is new, its imperfectly round pistons and rings were squeezed into imperfectly round cylinders. Mercury, as any manufacturer,...
Showing results 1 to 25 of 377

 
Forum Jump

All times are GMT -6. The time now is 05:00 PM.


Powered by vBulletin® Version 3.8.8
Copyright ©2000 - 2021, vBulletin Solutions, Inc.
vBulletin Security provided by vBSecurity v2.2.2 (Pro) - vBulletin Mods & Addons Copyright © 2021 DragonByte Technologies Ltd.