Home   |  Message Board   |  Information   |  Classifieds   |  Features   |  Video  |  Boat Reviews  |  Boat DIY
Walleye Message Central - Search Results
Walleye Message Central

Go Back   Walleye Message Central > Search Forums

Showing results 1 to 14 of 14
Search took 0.01 seconds.
Search: Posts Made By: GerGa
Forum: Electronics 05-14-2021, 06:25 AM
Replies: 4
Views: 281
Posted By GerGa
I've tried dielectric grease but It didn't work. ...

I've tried dielectric grease but It didn't work. It shouldn't work because it is non-conductive.
Forum: Electronics 05-13-2021, 07:54 PM
Replies: 4
Views: 281
Posted By GerGa
Garmin mount connectors corrosion

Hi, my small Garmin gps mount has two 4 pin female connectors which look a little corroded. Sometimes it does not turn on fully and will flash a low brightness screen then turn off. Last year was...
Forum: Electronics 12-10-2020, 05:08 PM
Replies: 38
Views: 4,712
Posted By GerGa
Just make sure your chargers works with...

Just make sure your chargers works with agms..they've been around a while so I think so it shouldn't be a problem.
Forum: Electronics 12-10-2020, 03:42 PM
Replies: 38
Views: 4,712
Posted By GerGa
I can't comment on those but I used an...

I can't comment on those but I used an SLI27MAGMDC group 27 AGM from batteries plus. It came out to $210 after core returned, tax, 10% off code. They have a 10% off code still and you have to...
Forum: Electronics 12-09-2020, 07:25 AM
Replies: 38
Views: 4,712
Posted By GerGa
AGM batteries are supposed to take vibration much...

AGM batteries are supposed to take vibration much better than flooded batteries. I went with AGM on my boat because the battery compartment is in the front where the boat can pound more in choppy...
Forum: General Discussion 10-02-2020, 03:21 PM
Replies: 86
Views: 13,092
Posted By GerGa
I have one comment on using paypal. You should...

I have one comment on using paypal. You should always do the friends and family option, as it provides no option for the buyer to get their money back. If you do the other type of paypal...
Forum: Electronics 06-27-2020, 12:26 PM
Replies: 13
Views: 2,596
Posted By GerGa
Yes i I acknowledged that Schumacher makes a...

Yes i I acknowledged that Schumacher makes a marine charger but nobody looking for a charger for their boat is going to look for one. Best off going with a dual pro or minnkota. Trusted brands...
Forum: Electronics 06-27-2020, 07:12 AM
Replies: 13
Views: 2,596
Posted By GerGa
The charger says deep cycle on it next to the 10a...

The charger says deep cycle on it next to the 10a charge light. Either way it can't be good for car batteries either.
Forum: Electronics 06-26-2020, 09:23 PM
Replies: 13
Views: 2,596
Posted By GerGa
Thanks for alerting me to this. I took it off...

Thanks for alerting me to this. I took it off the charger that night. I did some research and found you are right, max voltage should be more like 14.8 volts or less depending on certain factors. ...
Forum: Electronics 06-18-2020, 07:38 PM
Replies: 13
Views: 2,596
Posted By GerGa
Battery stuck charging at 99%

Hi, this is my first boat and deep cycle battery for the trolling motor and depth finder. Just bought a Duracell group 27 agm battery and am charging it the first time on a fairly new Schumacher...
Forum: Motors and Props 05-14-2020, 07:19 PM
Replies: 7
Views: 901
Posted By GerGa
Well my motor started and ran perfect today via...

Well my motor started and ran perfect today via the pull cord on the flywheel. I shut it down and started it multiple times. I think the throttle was definitely turned up when I first started it.
Forum: Motors and Props 05-13-2020, 01:02 PM
Replies: 7
Views: 901
Posted By GerGa
The cord normally wraps around the large black...

The cord normally wraps around the large black spool. The cord became unwrapped from the spool and around the white thing in the center. When that happened the spool was spinning with the engine...
Forum: Motors and Props 05-13-2020, 08:54 AM
Replies: 7
Views: 901
Posted By GerGa
The cord is what burned, but the mechanism seems...

The cord is what burned, but the mechanism seems fine. Should I be able to put a new cord back in the mechanism on my own? I don't know how hard that is to do.
Forum: Motors and Props 05-12-2020, 08:28 PM
Replies: 7
Views: 901
Posted By GerGa
Yamaha F25 rough start

Hi,
I have a 2017 Yamaha F25 tiller pull start that I bought with a boat last fall and have not used it yet. This is my first boat. This is the first year of the redesigned engine with EFI. It...
Showing results 1 to 14 of 14

 
Forum Jump

All times are GMT -6. The time now is 08:14 AM.


Powered by vBulletin® Version 3.8.8
Copyright ©2000 - 2021, vBulletin Solutions, Inc.
vBulletin Security provided by vBSecurity v2.2.2 (Pro) - vBulletin Mods & Addons Copyright © 2021 DragonByte Technologies Ltd.