Home   |  Message Board   |  Information   |  Classifieds   |  Features   |  Video  |  Boat Reviews  |  Boat DIY
Walleye Message Central - Search Results
Walleye Message Central

Go Back   Walleye Message Central > Search Forums

Showing results 1 to 25 of 432
Search took 0.03 seconds.
Search: Posts Made By: Ndstallmann
Forum: General Discussion Today, 08:01 PM
Replies: 19
Views: 698
Posted By Ndstallmann
I had a fuel oil furnace, replaced it with a high...

I had a fuel oil furnace, replaced it with a high efficiency LP furnace. My heating bill for the winter went up. Put my hand on the exhaust and immediately knew why . The old furnace exhaust was 135...
Forum: Motors and Props 10-17-2020, 07:06 AM
Replies: 13
Views: 880
Posted By Ndstallmann
Rule of thumb in batteries weigh Equals power....

Rule of thumb in batteries weigh Equals power. So does 3 size 24 batteries weigh more the 2 size 31 ? And full speed is not the test you want to do, cause the 36 volt is going to go faster. You...
Forum: General Discussion 10-11-2020, 08:27 AM
Replies: 26
Views: 1,946
Posted By Ndstallmann
Great story.

Great story.
Forum: Motors and Props 09-05-2020, 12:25 PM
Replies: 24
Views: 2,094
Posted By Ndstallmann
I had a 1950 SST and a 150 Verado. I used a high...

I had a 1950 SST and a 150 Verado. I used a high five to lift the stern a little more and I got on plane a 17 mph rather the 23 mph. I liked that a lot better then looking over the bow till I was on...
Forum: General Discussion 09-04-2020, 12:59 PM
Replies: 9
Views: 932
Posted By Ndstallmann
Just hooked up the Wi Fi extender from the link...

Just hooked up the Wi Fi extender from the link in HRG post. Works great . Thanks for the info everyone!
Forum: General Discussion 08-30-2020, 05:32 PM
Replies: 41
Views: 4,275
Posted By Ndstallmann
[QUOTE=MK24;6478744]There should be a requirement...

[QUOTE=MK24;6478744]There should be a requirement for operating a boat or water craft that horsepower can not exceed IQ ![/QUOTE

In practice it appears to to be the inverse of this rule.
Forum: Electronics 08-30-2020, 05:18 PM
Replies: 17
Views: 1,445
Posted By Ndstallmann
Room is always a question. Can have room for one...

Room is always a question. Can have room for one big screen but not 2 little screens and vise-versa. But if was me and room wasnít a concern I would go with 2 screens . I had my lone fish finder...
Forum: Motors and Props 08-24-2020, 12:50 PM
Replies: 2
Views: 379
Posted By Ndstallmann
I have used a ď flapper discĒ donít know the...

I have used a ď flapper discĒ donít know the correct name, thatís what I call them probably a 80 grit or higher so you donít take of to much metal. On a 4 1/2Ē grinder. Hopefully theyíre all ding...
Forum: Trailers and Tow Vehicles 08-23-2020, 02:56 PM
Replies: 17
Views: 1,649
Posted By Ndstallmann
Those brackets in REW post look like the flimsy...

Those brackets in REW post look like the flimsy ones I had. That why I had to build my own.
Forum: Trailers and Tow Vehicles 08-22-2020, 08:57 AM
Replies: 17
Views: 1,649
Posted By Ndstallmann
I bought tall poles, work well the first time....

I bought tall poles, work well the first time. Second time wind was too much,bent the metal supports and bracket. So I made a set out of heavy gauge square tubing, and slid then in larger square...
Forum: Boats 08-14-2020, 12:44 AM
Replies: 16
Views: 1,520
Posted By Ndstallmann
Do a little research on what SS steel...

Do a little research on what SS steel Screw-material is the best. I believe it is 18-8 stainless. I know I get mine from McMaster- Carr. And replace the screws , the ones you have are probably not...
Forum: Trailers and Tow Vehicles 08-08-2020, 12:41 PM
Replies: 5
Views: 504
Posted By Ndstallmann
I would see if you can get Doug fir, probably...

I would see if you can get Doug fir, probably have to buy a 2x12 and cut in rip in too. Thatís the only way I could get Doug fir at my lumber yard. I also routed the edges so they werenít as sharp....
Forum: General Discussion 08-06-2020, 09:29 AM
Replies: 32
Views: 4,238
Posted By Ndstallmann
I have a tandem axle go to South Dakota, speed...

I have a tandem axle go to South Dakota, speed limit 80 mph. At about 75 mine gets squirrelly, so I donít go over 70, margin of safety.
Forum: Boats 08-04-2020, 11:19 AM
Replies: 4
Views: 704
Posted By Ndstallmann
I would buy a good boat rather then a ruff boat....

I would buy a good boat rather then a ruff boat. My Dad always told me you canít make a silk purse out of a sows ear. A lesson Iíve learned many times cause I didnít always take his advice.
Forum: General Discussion 07-30-2020, 06:14 AM
Replies: 13
Views: 1,130
Posted By Ndstallmann
The power broom is new to me. Great idea. Learn...

The power broom is new to me. Great idea. Learn something new everyday.
Forum: General Discussion 07-29-2020, 09:07 PM
Replies: 13
Views: 1,130
Posted By Ndstallmann
Go to mernards buy about 2.5 gpm 3000 psi gas...

Go to mernards buy about 2.5 gpm 3000 psi gas power washer. About $400 and let him go to town on your drive. And then you have it to use on your car and boat....
Forum: Electronics 07-19-2020, 07:44 AM
Replies: 2
Views: 338
Posted By Ndstallmann
I had same thing on mime. ( 2008 much older ) but...

I had same thing on mime. ( 2008 much older ) but I had water in the motor. Eventually just quit.
Forum: Trailers and Tow Vehicles 07-13-2020, 05:48 AM
Replies: 18
Views: 1,199
Posted By Ndstallmann
Iím pretty sure those rubber boots have a hole in...

Iím pretty sure those rubber boots have a hole in them , you donít need to pry them off
Forum: Trailers and Tow Vehicles 07-12-2020, 06:47 PM
Replies: 18
Views: 1,199
Posted By Ndstallmann
Looking again at your pictures I might have...

Looking again at your pictures I might have pulled just the caliper bolts. ( Iím a electrician -maintenance man I work on a lot of different things and canít remember it all.)
Forum: Trailers and Tow Vehicles 07-12-2020, 06:43 PM
Replies: 18
Views: 1,199
Posted By Ndstallmann
I did mine last year donít quite remember what I...

I did mine last year donít quite remember what I did. But look in my boat trailer tools kit and I have a 3/8 ball end Allen wrench cut off (the full length) along with a 6 point 3/8 socket. So Iím...
Forum: Strictly Fishing 07-07-2020, 09:31 PM
Replies: 9
Views: 723
Posted By Ndstallmann
Was out on Spirit today , did see 3 walleye...

Was out on Spirit today , did see 3 walleye caught. I wasnít lucky today.
Forum: Strictly Fishing 07-06-2020, 09:25 PM
Replies: 9
Views: 723
Posted By Ndstallmann
Only one time so far. I only live 60 miles away....

Only one time so far. I only live 60 miles away. But sometimes other things are more pressing. Been fishing on Silver lake more this year. About 10 miles from Spirit, and 10 miles closer for me.
Forum: Strictly Fishing 07-06-2020, 07:33 PM
Replies: 9
Views: 723
Posted By Ndstallmann
Talk to them today very helpful. A young couple...

Talk to them today very helpful. A young couple took it over about 5 years ago. Much better service
Forum: Strictly Fishing 07-06-2020, 04:25 PM
Replies: 9
Views: 723
Posted By Ndstallmann
The bait shop at Spirit lake has always been...

The bait shop at Spirit lake has always been helpful. Kabeleís 712-336-1512.
Forum: Strictly Fishing 07-05-2020, 12:09 PM
Replies: 17
Views: 6,739
Posted By Ndstallmann
I just use the standard 3700 divided in 4 rows. I...

I just use the standard 3700 divided in 4 rows. I donít use cross dividers each row holds about 6 bottom bouncers. Keep them separated by size.
Showing results 1 to 25 of 432

 
Forum Jump

All times are GMT -6. The time now is 11:13 PM.


Powered by vBulletin® Version 3.8.8
Copyright ©2000 - 2020, vBulletin Solutions, Inc.
vBulletin Security provided by vBSecurity v2.2.2 (Pro) - vBulletin Mods & Addons Copyright © 2020 DragonByte Technologies Ltd.