Forum: Electronics
01-02-2024, 10:40 AM
|
Replies: 20
Views: 3,579
|
Forum: Motors and Props
07-10-2023, 01:39 PM
|
Replies: 18
Views: 9,965
|
Forum: Electronics
05-26-2023, 01:14 PM
|
Replies: 5
Views: 1,242
Installed the updates on my HDS12, Carbon, and...
Installed the updates on my HDS12, Carbon, and AT2:
It appears they broke the function of the yellow wake-up wire. My AT2 powers up regardless if the yellow wire is connected to the HDS12 or not....
|
Forum: Boats
05-24-2023, 08:58 AM
|
Replies: 10
Views: 3,125
|
Forum: Electronics
04-29-2023, 05:59 PM
|
Replies: 13
Views: 2,004
A feature of the iTroll that I really like is...
A feature of the iTroll that I really like is called "HUNT" mode.
You can program it to troll along at idle (or any other speed) for three minutes (or any time you desire) and then it will speed up...
|
Forum: Electronics
08-07-2022, 11:13 PM
|
Replies: 10
Views: 2,146
Thanks for the link
I figured I'd show you what is possible and add another tip. I just put all the .AT5 files that were created by Insight Map Creator into a directory named "BOYD" on a 32 gig micro SD card. Turned...
|
Forum: Electronics
08-06-2022, 04:44 PM
|
Replies: 10
Views: 2,146
It takes a bit of work!
This has been a "work-in-progress" for me as well.
I was able to get a satellite view of a local lake (Lake Boyd) and a couple of Wyoming prairie lakes by using SAS Planet (Google it) and Insight...
|
Forum: Motors and Props
08-04-2022, 11:29 AM
|
Replies: 8
Views: 2,306
I'd Love To Try a 15"
Yeh, I hear yah. Mercury spec for the 150 plain jane 4 stroke is 5000-5800 WOT. Note that it was also very hot out. I've seen 5400 rpm with the 17" on a cold damp morning. I'd love to try a 15"...
|
Forum: Motors and Props
08-04-2022, 10:45 AM
|
Replies: 43
Views: 29,040
PN: 8M0054695 Has Been Superceded........
.......... by PN: 23-8M0187255
A much improved design. For sure, I thought I got the wrong part as the old one has four wimpy tabs and the new one only has three tabs. Tabs are much beefier and...
|
Forum: Motors and Props
08-03-2022, 07:15 PM
|
Replies: 8
Views: 2,306
|
Forum: Boats
04-13-2022, 02:49 PM
|
Replies: 25
Views: 3,472
The Merc trim/tilt limit module simply cuts off...
The Merc trim/tilt limit module simply cuts off the electric hydraulic pump when it hits the pre-programmed limit. To program the upper limit, the module kit comes with a jumper that you plug in and...
|
Forum: Boats
04-13-2022, 09:55 AM
|
Replies: 25
Views: 3,472
A Couple of Points
For some reason, the LUND manual will say to NOT use the ski pole to pull "tubers". Don't know why it's ok to pull a skier but not tubes?
Re motor hitting the ski pole: Mercury sells a tilt/trim...
|
Forum: Motors and Props
03-27-2022, 10:13 AM
|
Replies: 30
Views: 6,130
You bet on ALTITUDE slayer. I've got the same...
You bet on ALTITUDE slayer. I've got the same boat, just a year older. Boyd Lake near where I live is 4960. When I picked up my boat at Rapid Marine in MN, I should have talked them into a 17"...
|
Forum: Boats
02-27-2022, 10:27 PM
|
Replies: 17
Views: 4,067
.... and no one answered the original question?
My 2019 LUND Impact 1875 XS has, from the factory, a #6 pair of wires from the cranking battery to the helm. Behind the helm switch panel the #6 is sized down to a #10 via an Anderson Power Pole DC...
|
Forum: Motors and Props
09-23-2021, 05:41 PM
|
Replies: 16
Views: 2,110
It's working its heart out!
Whoa! There's a flag right there Minnow. If the alternator voltage is dropping to 11.8-11.9 while running at higher RPMs you've got something that's overloading it for sure and it's getting hot and...
|
Forum: Motors and Props
07-03-2021, 07:28 PM
|
Replies: 8
Views: 1,575
I recently purchased a Mercury Spitfire 4 blade...
I recently purchased a Mercury Spitfire 4 blade aluminum (the one rated for 150hp+) in 17" pitch for my Impact 1875 with a 150hp 4 stroke. I like it a lot. Almost better than the 3 blade stainless...
|
Forum: Motors and Props
04-16-2021, 01:27 PM
|
Replies: 4
Views: 1,145
|
Forum: Motors and Props
01-12-2021, 11:21 AM
|
Replies: 26
Views: 3,271
My2019 Impact 1875 Prop Experience
Boat came with a 19" pitch 3-blade Black Max mounted on my 150 hp 4 stroke. I'm at altitude (5000' plus) so knew I'd probably need to go to 17 or 15 inch pitch. Altitude really, really effects a...
|
Forum: Electronics
12-26-2020, 04:49 PM
|
Replies: 14
Views: 8,979
|
Forum: Boats
11-11-2020, 08:30 AM
|
Replies: 5
Views: 1,790
I'm afraid y'all are probably right on dealing...
I'm afraid y'all are probably right on dealing with the dealer. Guess I'll call the local dealer (from whom I did not buy the boat) and give it a try. I always feel a bit sheepish about calling the...
|
Forum: Boats
11-10-2020, 10:40 AM
|
Replies: 5
Views: 1,790
Need Lund Part# for 1875 Impact Livewell Divider
Yes, I know I could probably make one. However, at age 76 and lazy I'd rather just buy it. I understand it's about a $20 option but my 2019 did not come with it. My dealer is a long ways off so...
|
Forum: Boats
11-03-2020, 05:06 PM
|
Replies: 12
Views: 6,061
|