Home   |  Message Board   |  Information   |  Classifieds   |  Features   |  Video  |  Boat Reviews  |  Boat DIY
Walleye Message Central - Search Results
Walleye Message Central

Go Back   Walleye Message Central > Search Forums

Showing results 1 to 25 of 418
Search took 0.08 seconds.
Search: Posts Made By: Ches
Forum: General Discussion 03-31-2021, 01:33 PM
Replies: 17
Views: 1,784
Posted By Ches
No, but maybe you are.....

No, but maybe you are.....
Forum: General Discussion 03-31-2021, 01:16 PM
Replies: 17
Views: 1,784
Posted By Ches
I had a nose job first (one side 100% blocked),...

I had a nose job first (one side 100% blocked), then got a c-pap. I sleep like a baby.
Forum: General Discussion 03-31-2021, 01:13 PM
Replies: 37
Views: 5,962
Posted By Ches
Thanks for the post, I didn't see the first post....

Thanks for the post, I didn't see the first post.
Ches.
Forum: General Discussion 03-31-2021, 01:09 PM
Replies: 10
Views: 1,061
Posted By Ches
Do yourself a favor and launch on a straight...

Do yourself a favor and launch on a straight launch once or twice first so you get used to it. I love it but took a few tries to get it set-up right or most of for me to figure out what to expect....
Forum: General Discussion 03-31-2021, 01:01 PM
Replies: 53
Views: 7,331
Posted By Ches
You have not looked closer at a Drotto. Once the...

You have not looked closer at a Drotto. Once the nose of the boat is on land, you can hook up your winch and safety hook. So in essence you have added a third level of protection on the road.
Ches....
Forum: General Discussion 03-29-2021, 09:19 PM
Replies: 53
Views: 7,331
Posted By Ches
I don't have steps yet, might be in future. I do...

I don't have steps yet, might be in future. I do have a Drotto for the last two years and it is a god send for loading by yourself. Boat is a Lund Pro Guide 2010.
Ches,
Forum: Electronics 06-16-2020, 08:42 AM
Replies: 15
Views: 2,020
Posted By Ches
That's what I always do when unsure of wiring. I...

That's what I always do when unsure of wiring. I disconnect battery and check continuity for negative. Leave it connected to check for power. Make sure power cuts off when master is turned off so you...
Forum: Motors and Props 06-01-2020, 06:59 PM
Replies: 5
Views: 1,369
Posted By Ches
I could too. With the weight of my outboard and...

I could too. With the weight of my outboard and 40 gal. of gas, you could put a lot of batteries in the mid section of the boat. Maybe that's where BRP is going.
Ches.
Forum: Motors and Props 05-31-2020, 07:18 PM
Replies: 5
Views: 1,369
Posted By Ches
If it were German vs. British I would have more...

If it were German vs. British I would have more faith.
Forum: Motors and Props 05-31-2020, 03:59 PM
Replies: 30
Views: 7,217
Posted By Ches
The first 4S I ever saw was a Johnson, all I...

The first 4S I ever saw was a Johnson, all I could hear was the pisser water hitting the water to know it was running. I was blown away because all I knew were 2S in those days. Someplace I was told...
Forum: Motors and Props 05-31-2020, 08:37 AM
Replies: 30
Views: 7,217
Posted By Ches
Kind of surprised not to see a post from Bobby on...

Kind of surprised not to see a post from Bobby on this. We were just talking about this last week on our fishing trip and how I was surprised that BRP has gone 4S with their SeaDoo and I think Skidoo...
Forum: Boats 05-21-2020, 07:50 PM
Replies: 6
Views: 698
Posted By Ches
I tried them, they said they didn't make the...

I tried them, they said they didn't make the cover so they didn't have the pattern.
Forum: Boats 05-20-2020, 02:28 PM
Replies: 6
Views: 698
Posted By Ches
Ok, I found the tag, unfortunately it was...

Ok, I found the tag, unfortunately it was unreadable. Anyone else have the part number for a 2010?
Forum: Motors and Props 05-19-2020, 09:34 AM
Replies: 14
Views: 1,416
Posted By Ches
Have you checked your isolator to see if it is...

Have you checked your isolator to see if it is working properly? Remove all three leads (alt output, positives from both batteries, be careful, they are hot). Take a multi meter and check...
Forum: Motors and Props 05-18-2020, 09:21 AM
Replies: 8
Views: 1,465
Posted By Ches
Muskeye What size Rev4 did you end up with. I...

Muskeye
What size Rev4 did you end up with. I am lucky I only live 20 minutes from John's shop. I picked up a 19P Rev4 off Scream and Fly that I was going to have John go over till I found a 20P...
Forum: Motors and Props 05-18-2020, 08:34 AM
Replies: 12
Views: 1,595
Posted By Ches
Kyle I have a 2013 2010 Pro Guide with a...

Kyle
I have a 2013 2010 Pro Guide with a Flashed 150 Verado (should be just north of 200). I raised my motor one hole (from 2nd to middle) Based on advice from the Mercury Pro Prop guys and Videos...
Forum: Motors and Props 05-18-2020, 08:22 AM
Replies: 12
Views: 1,595
Posted By Ches
JAK The Spitfire is an aluminum 4 blade prop,...

JAK
The Spitfire is an aluminum 4 blade prop, the Spitfire X7 is the SS version. I had the Aluminum version on my last boat and it was the only prop that I could get the boat to run right with. I...
Forum: Motors and Props 05-17-2020, 09:10 PM
Replies: 14
Views: 1,416
Posted By Ches
I must be slow, so you have 5 batteries, 2 for...

I must be slow, so you have 5 batteries, 2 for the TM and 3 for starting, power steering and locators?
Forum: Motors and Props 05-17-2020, 08:32 AM
Replies: 14
Views: 1,416
Posted By Ches
Do you have a battery Isolator on your boat?...

Do you have a battery Isolator on your boat? Would be nice if you could charge both batteries when running but not let steering pump draw down starting battery. Does not sound like you have an...
Forum: Motors and Props 05-17-2020, 08:20 AM
Replies: 24
Views: 3,441
Posted By Ches
JAK Very good post, I agree with almost all of...

JAK
Very good post, I agree with almost all of it. I have a very light boat compared to the OP's. The Tempest was my go to prop prior to raising motor one hole. When I did that, both the Tempest...
Forum: Motors and Props 05-16-2020, 07:39 PM
Replies: 24
Views: 3,441
Posted By Ches
Try a 20 or 19P Rev 4. I have mine in the middle...

Try a 20 or 19P Rev 4. I have mine in the middle hole. Best guess would be the 20 and raise your motor. Good luck, its kind of a crap shoot to get it right. But it's all worth it once you get...
Forum: Boats 05-15-2020, 12:16 PM
Replies: 6
Views: 698
Posted By Ches
Thanks, I will look it over good next time I take...

Thanks, I will look it over good next time I take it off. Had it 6 years now and have not noticed one, but them I was not looking either. You know how it goes, either taking it off or putting it on...
Forum: Boats 05-15-2020, 09:34 AM
Replies: 6
Views: 698
Posted By Ches
LUND 2013 20'Pro Guide Travel Cover

Anyone know the part number for the travel cover (the one that stops prior to getting to the front) for a 2013 Lund Pro Guide 2010 model? Mine is still in good shape but know I will need one soon....
Forum: Boats 05-13-2020, 08:32 AM
Replies: 28
Views: 3,221
Posted By Ches
On my old boat, I went from a 60HP 2S to a 60HP...

On my old boat, I went from a 60HP 2S to a 60HP 4S, Top speed was about the same but hole shot and planning were very bad with the 4S. I put Pro Trollers on the boat and they made a world of...
Forum: Motors and Props 05-13-2020, 07:50 AM
Replies: 24
Views: 3,441
Posted By Ches
Make sure your motor height is set properly,...

Make sure your motor height is set properly, cavitation plate should be showing in the spray when on plane. Have a buddy take a video for you, I have found, at least on my boat, that the Tempest...
Showing results 1 to 25 of 418

 
Forum Jump

All times are GMT -6. The time now is 02:06 AM.


Powered by vBulletin® Version 3.8.8
Copyright ©2000 - 2021, vBulletin Solutions, Inc.
vBulletin Security provided by vBSecurity v2.2.2 (Pro) - vBulletin Mods & Addons Copyright © 2021 DragonByte Technologies Ltd.