Home   |  Message Board   |  Information   |  Classifieds   |  Features   |  Video  |  Boat Reviews  |  Boat DIY
Walleye Message Central - Search Results
Walleye Message Central

Go Back   Walleye Message Central > Search Forums

Showing results 1 to 25 of 66
Search took 0.02 seconds.
Search: Posts Made By: Cooter
Forum: Motors and Props 03-12-2014, 11:04 AM
Replies: 13
Views: 2,715
Posted By Cooter
REW, That is correct. My current setup is 8...

REW,
That is correct. My current setup is 8 gauge wire (1 red/1 black) from my 2 batteries (wired together with jumper cables) to the plug that
I've attached photographs of in my first post. My...
Forum: Motors and Props 03-12-2014, 09:44 AM
Replies: 13
Views: 2,715
Posted By Cooter
Ok, thanks. So what I'm hearing is leave...

Ok, thanks. So what I'm hearing is leave everything the same (except adding a 50 amp breaker). Run 8 gauge wire for my jumpers, and I should have no problems. I will monitor the plug, but if I had...
Forum: Motors and Props 03-12-2014, 09:21 AM
Replies: 13
Views: 2,715
Posted By Cooter
Ok, thanks HRG. I see that Minn Kota makes a...

Ok, thanks HRG. I see that Minn Kota makes a plug (MKR 18) that it claims is for 12, 24, or 36 volt systems. It says it will take 6 gauge wire which I am now considering. I can't find information...
Forum: Motors and Props 03-12-2014, 07:19 AM
Replies: 13
Views: 2,715
Posted By Cooter
Jumper Wires and Trolling Motor Plug

I'm installing a Terrova 101 on my boat, and after suggestions from this site I'm staying with the 8 gauge wire that the boat was pre-wired with (6' run from batteries to plug). I've attached some...
Forum: Boats 12-04-2013, 02:54 PM
Replies: 2
Views: 770
Posted By Cooter
Wiring 24V and 36V trolling motors..Will this work?

I purchased a boat with a transom mount trolling motor (MK Vector 80lb 24V) that only has one positive and one negative wire. It's wired for 24V by jumper wires between the batteries. I'm looking...
Forum: Electronics 08-19-2013, 07:34 PM
Replies: 1
Views: 910
Posted By Cooter
Lowrance Problems

While I was adjusting my electronics the other day the pins on my blue network connector for the back of my unit pulled through the blue plastic piece. Didn't seem like a big deal at the time...
Forum: Boats 08-19-2013, 09:26 AM
Replies: 1
Views: 800
Posted By Cooter
Lund Tiller Electronic Box Help

I've got an '04 Pro-V tiller, and wanted to do some updating with electronics. When I pulled out my electronics I noticed the wires for the old electronics are pinched between the left wall of the...
Forum: Boats 07-24-2013, 12:22 PM
Replies: 7
Views: 1,366
Posted By Cooter
Anybody know where I can purchase this boat pedestal?

It's a springfield, and I can find the aluminum part of it, but I can't find one that has the plastic insert. It's in a 2004 lund boat. The seat poles just slide around the plastic, and do not pop...
Forum: Motors and Props 03-26-2013, 09:09 AM
Replies: 12
Views: 1,384
Posted By Cooter
Ok thanks. I took a look and attached picture. ...

Ok thanks. I took a look and attached picture. Looks to be carbed. I bought it from a guy who used it very little. Only 60 hours on the motor. I've read about problems with the carbs. Any...
Forum: Electronics 10-15-2010, 12:03 PM
Replies: 26
Views: 4,009
Posted By Cooter
Guest 1234

After I sent them an e-mail explaining problems with my 111 they told me to send it in with $600 for a repair. After further explaining the problem they told me it was the puck then told me to send...
Forum: Electronics 10-14-2010, 01:17 PM
Replies: 26
Views: 4,009
Posted By Cooter
Guest1234

I've had a similar experience lately while trying to get service on my 111. Terrible. Would have had better luck talking to the wood desk I'm sitting behind. Customer Service is terrible, and my...
Forum: Electronics 07-29-2010, 05:34 AM
Replies: 5
Views: 1,452
Posted By Cooter
Guest

T-Mac,
Sounds like a similar problem to my LCX-111 HD. Using a lakemaster chip, and having problems with the chart freezing up. The only advice I've got on the issue is to ensure the unit has...
Forum: Electronics 07-24-2010, 07:18 AM
Replies: 0
Views: 835
Posted By Cooter
LCX-111 HD Problem???

For some reason my map/gps keeps locking up while I'm on the water. The unit will function fine, and the sonar will continue to work. Some days I can go all day without a problem, but other days I...
Forum: Electronics 02-15-2010, 04:36 PM
Replies: 14
Views: 2,365
Posted By Cooter
Do you have a diagram on how to run power to the...

Do you have a diagram on how to run power to the GPS module?
Forum: Electronics 02-15-2010, 02:32 PM
Replies: 14
Views: 2,365
Posted By Cooter
What am I doing wrong?

I just purchased a LCX-111C HD...I keep getting a message that GPS module is not responding...I've looked through the manuals, and it appears I have everything hooked up correctly. Any tips or...
Forum: Electronics 02-04-2010, 06:48 AM
Replies: 2
Views: 859
Posted By Cooter
Help With Decision

I'm looking to upgrade my units on the console of my boat.

I've located a 2005 LCX-111C HD for $650 (without transducer) in good condition. This would allow me to have just one unit at the...
Forum: Electronics 07-01-2009, 12:24 PM
Replies: 5
Views: 1,023
Posted By Cooter
I have a manual, and it was also my understanding...

I have a manual, and it was also my understanding that contour lines should automatically load when I put the chip in....I have two chips (Wisconsin North Inland & Lake Michigan Offshore)...The...
Forum: Electronics 07-01-2009, 02:14 AM
Replies: 5
Views: 1,023
Posted By Cooter
Help With Garmin GPS

I recently purchased a new boat, and it has a Garmin GPSMAP 185 on it...It's an older unit (2001), but has to do for now...I have G-Charts for my area, but can't get contour lines to show up on the...
Forum: Electronics 06-18-2009, 02:19 AM
Replies: 55
Views: 11,408
Posted By Cooter
Last two purchases (H20 & LCX-15MT) from Lowrance...

Last two purchases (H20 & LCX-15MT) from Lowrance were nothing but headaches...Lucky if I could get either to hold a satellite (and bottom on the x-15)....Lost a lot of hours of my life put on hold...
Forum: Boats 05-27-2009, 07:23 PM
Replies: 14
Views: 6,329
Posted By Cooter
Mariner's were built by Mercury at that time, and...

Mariner's were built by Mercury at that time, and can be best compared with the Merc EFI's....They like fuel/oil, but will run forever...IMHO these motors were what built Mercury's reputation...If...
Forum: Swap Board - $500 LIMIT ON ALL POSTS, INCLUDING WTB. 03-14-2009, 01:23 AM
Replies: 1
Views: 600
Posted By Cooter
WTB: Transducer for LCX-15MT

Figured I'd give it a shot before I buy a brand new one. Looking for a transom mount. Thanks
Forum: Boats 03-05-2009, 11:51 PM
Replies: 2
Views: 1,046
Posted By Cooter
Carpet Lifting...HELP

The carpet on the interior of my ranger is starting to lift on edges and corners. What is the best adhesive to use? The boats getting to the age where the carpet could be replaced, but I'd just...
Forum: Strictly Fishing 03-02-2009, 12:15 AM
Replies: 23
Views: 3,347
Posted By Cooter
PJ I'd be real interested. Pics would be great. ...

PJ I'd be real interested. Pics would be great. Work good on rivers around here, but hard to find unpainted ones.
Forum: Boats 02-25-2009, 09:19 PM
Replies: 7
Views: 1,775
Posted By Cooter
Own a '96 692 with a Merc 175 EFI...Good ride,...

Own a '96 692 with a Merc 175 EFI...Good ride, decent layout, and it moves...if you want any additional information PM me. Been running this setup for 5 years, and haven't brought myself to...
Forum: Motors and Props 02-25-2009, 09:02 PM
Replies: 12
Views: 1,883
Posted By Cooter
Thanks for all the input guys. It hasn't got...

Thanks for all the input guys. It hasn't got frustrating enough for me to take it in yet. It usually corrects itself quickly, and I haven't noticed it getting worse over the years. I think I'll...
Showing results 1 to 25 of 66

 
Forum Jump

All times are GMT -6. The time now is 12:42 AM.


Powered by vBulletin® Version 3.8.8
Copyright ©2000 - 2020, vBulletin Solutions, Inc.
vBulletin Security provided by vBSecurity v2.2.2 (Pro) - vBulletin Mods & Addons Copyright © 2020 DragonByte Technologies Ltd.