Home   |  Message Board   |  Information   |  Classifieds   |  Features   |  Video  |  Boat Reviews  |  Boat DIY
Walleye Message Central - Search Results
Walleye Message Central

Go Back   Walleye Message Central > Search Forums

Showing results 1 to 14 of 14
Search took 0.01 seconds.
Search: Posts Made By: lake_effect
Forum: Motors and Props 05-11-2021, 01:27 PM
Replies: 6
Views: 543
Posted By lake_effect
No they do not but mercury makes a hub to fit the...

No they do not but mercury makes a hub to fit the evinrude lower. Looking merc because I have heard mixed reviews on the rx4. Also the local prop shop told me I would have to buy each prop instead of...
Forum: Motors and Props 05-11-2021, 08:42 AM
Replies: 6
Views: 543
Posted By lake_effect
Yes its a G1, lower unit was replaced in '16...

Yes its a G1, lower unit was replaced in '16 under warranty as well.

Sent from my SM-G973U1 using Tapatalk
Forum: Motors and Props 05-11-2021, 08:11 AM
Replies: 6
Views: 543
Posted By lake_effect
Anyone run a Merc Rev 4 or High 5 on an Etec 250?

Purchased a 2014 620vs with an Etec 250 HO with 1.85 lower unit and 15 kicker. Boat came with Rebel 21 and 23 pitch props. RPM's and speed are good with the 21 when loaded and will touch the limiter...
Forum: General Discussion 05-07-2021, 10:23 AM
Replies: 75
Views: 7,066
Posted By lake_effect
National cost is obviously higher than northeast...

National cost is obviously higher than northeast Wisconsin but here the charger and install costs should be $600-$1100. If the customer is already on or elects to change to a time of use or off-peak...
Forum: General Discussion 05-05-2021, 01:47 PM
Replies: 75
Views: 7,066
Posted By lake_effect
I work for an electric co-op and take care of our...

I work for an electric co-op and take care of our ev charging program and have looked into this more than I care to admit. For guys that pull boats long distances, travel cross country, etc no they...
Forum: General Discussion 05-03-2021, 08:31 AM
Replies: 31
Views: 3,421
Posted By lake_effect
So you're saying you don't know how to cook ducks...

So you're saying you don't know how to cook ducks or tried to eat Mergansers and coots.

Sent from my SM-G973U1 using Tapatalk
Forum: General Discussion 03-18-2021, 07:56 AM
Replies: 18
Views: 2,015
Posted By lake_effect
If you are spooling with 10 lb mono all the dive...

If you are spooling with 10 lb mono all the dive curves are set to Trilene XT, which is the same diameter as 14 lb Trilene XL. Just an FYI so you can get your lures to the most accurate depths...
Forum: Boats 12-15-2020, 07:27 AM
Replies: 1
Views: 382
Posted By lake_effect
Ranger 620fs sport top

Tried searching for this but couldn't find much. One of my wife's stipulations for the new boat is a sport top or bimini. Would like something that can be up for her and the kids to hide under but...
Forum: Electronics 07-26-2020, 06:58 PM
Replies: 6
Views: 778
Posted By lake_effect
Just with inaccurate and vague mapping. Going...

Just with inaccurate and vague mapping. Going through areas I know have certain structure and the mapping doesn't line up with the depths I am reading. Showing structure up to a half mile away from...
Forum: Electronics 07-26-2020, 06:17 PM
Replies: 6
Views: 778
Posted By lake_effect
I don't know about Little bay as I haven't been...

I don't know about Little bay as I haven't been up there yet this year but I made the switch to humminbird for mapping this summer. Pretty sure smart strike and lakemaster share the same data and I...
Forum: Motors and Props 07-23-2020, 11:44 AM
Replies: 11
Views: 1,203
Posted By lake_effect
My current prop is a 19p aluminum. I wasn't...

My current prop is a 19p aluminum. I wasn't planning to lower it, just stating where it was for reference. Like I said i am going to look for a used 17p trophy plus, rev 4 or high 5 to start and see...
Forum: Motors and Props 07-21-2020, 08:28 PM
Replies: 11
Views: 1,203
Posted By lake_effect
Thanks for the help guys. I wasn't sold on buying...

Thanks for the help guys. I wasn't sold on buying multiple aluminum props so they could get close and then buy a stainless one as well. I am running about 250 rpms low of acceptable range and 750 low...
Forum: Motors and Props 07-21-2020, 10:35 AM
Replies: 11
Views: 1,203
Posted By lake_effect
Testing new prop suggestions

Spoke with a local prop shop (Green Bay) and they suggested I buy an aluminum version of a prop they think should work before I drop a lot more on a stainless one and they should be able to tell what...
Forum: Electronics 05-18-2020, 11:07 AM
Replies: 1
Views: 595
Posted By lake_effect
Lakemaster, Autochart or Both?

Right now I have the navionics chip that came free with my Helix 7 and it works fine but just picked up an ipilot link upgrade head for my terrova and want to be able to utilize it so I need to run...
Showing results 1 to 14 of 14

 
Forum Jump

All times are GMT -6. The time now is 01:57 AM.


Powered by vBulletin® Version 3.8.8
Copyright ©2000 - 2021, vBulletin Solutions, Inc.
vBulletin Security provided by vBSecurity v2.2.2 (Pro) - vBulletin Mods & Addons Copyright © 2021 DragonByte Technologies Ltd.