Quote:
Originally Posted by Hot Runr Guy
That's a Packard GT280 connector, which is only rated to 25 amps. The light-colored piece snaps in, with a small flat screwdriver pry-up on 1 end, and it should pop out, for better cleaning.
Honestly, with the load the #10 wire has on it, powering the console, I'd cut the wire out, and use a heat-shrink splice to eliminate the disconnect.
https://www.youtube.com/watch?v=7ucH7XyAD54
HRG |
You are suggesting to cut the #10 wire and splice it and leave everything else?
I have been showing low voltage on my MDF even though my battery show 13 it would show 11.??, I am thinking this is probably why? Your thoughts?