Auger problem

[lyuluck]

If possible, I would like Tungsten Cobalt Alloy made 'Point blade', They are used in drilling holes on rocks, aluminum, steels.

[hnd]

yup buy new blades. we got to a point where our lazer's blades while sharp to use the unit jus twould not cut well. we replaced the blades and it was like knew again.

[Hook em through the lips]

It sounds like the blades are installed up side down. Just a thought for you

Sounds to me like you need your auger repitched. Often the pitch of the blade can be a little off and that will make cutting near impossible. I used to have to get my auger repitched a least once a season. I then got sick of dealing with it and bought a new auger and noticed that the old auger was missing 2 steal bars that the new auger had that keep the pitch from going out of whack. the old auger is now the earth auger and the good one is on my gas auger. good luck