![]() |
|
#1
|
|||
|
|||
![]()
have a 2014 tracker targa v18 115 four stroke if i trim the motor all the way down as far as it will go the boat got a noticable vibration if i hit the trim just a hair up goes away thought maybe the prop was bent put on new prop same thing. havent hit anything so shouldnt be a bent shaft any ideas
|
Sponsored Links | ||
Advertisement | ||
|
#2
|
||||
|
||||
![]()
It might not be related to the prop at all. My metal rod holders will rattle from time to time when trolling at just the right speed. When you hear the rattle just start touching stuff until you find it.
__________________
With my head in the sand about currant events it's hard to talk about fishing. |
#3
|
|||
|
|||
![]() Quote:
Some motors vibrate more than others ,depending if they are 3 cyl or 4,,,inline or V,,etc. Not much to worry about. If you had a bent propshaft or seriously out of balanced prop,you would notice it most at a hard throttle up to get up on plane. It would make no difference where you were trimmed. You could see and feel a very hard vibration both in the motor and the boat. You might also have a slight case of "prop rattle" which actually is a bit common on 4 strokes at idle in gear. Search "prop rattle " for more info. Unless excessive ,may not even notice it except when trimmed down against the stops. Not a real big deal. If severe, you may actually hear it. Last edited by MarkG; 06-24-2017 at 03:04 PM. |
Sponsored Links | ||
Advertisement | ||
|
#4
|
|||
|
|||
![]()
it does it just in gear at idle soon as i bump it up goes away
Last edited by tracker 18; 06-24-2017 at 05:14 PM. |
#5
|
|||
|
|||
![]()
No worries, sounds like what I said, when down against the stop, just more transfer to the bracket and transom.
|
![]() |
Thread Tools | |
Display Modes | |
|
|